Varnish Repair UV

Sand damaged area, then clean with silicone remover. Apply plastic adhesion promoter.

Shake up UV Primer, apply with approx. 1-2 spray passes (40-50 µm), followed by approx. 1 minute flash-off time.

Dry UV Primer with UV lamp for 4 minutes. (UV-A lamp light wavelength of 365-395 nm).

After drying, remove any adhesive film that may have formed with special UV cleaner, sand the surface, matte the edge zones.

Apply basecoat in 2-3 spray passes. Air dry.

Apply 1-2 coats of UV clear with intermediate exhaust air. Allow 1 minute flash time between coats.

Immediately after the UV clearcoat, apply UV Blender over the clear including edge areas. Allow to flash off for 1 minute.

Dry the surface with a UV lamp for 4 minutes. (UV-A lamp light wavelength of 365-395 nm).

After polishing, finished paint repair.